Sometimes, when creating new templates in the floating tab group, the mouse cursor will get stuck in the Text Select cursor while hovering over dock windows like Inspector and Variables. This seems to happen randomly?
In the floating tab groups title bar, you can no longer select the middle of it to drag/minimize/maximize the window, only the left and right.
This template causes 010 Editor to immediately crash:
const int32 Parameters[2] = {1, 2};
struct Structure(int32 parameters[2] = Parameters) {
local int32 value0 = parameters[0];
local int32 value1 = parameters[1];
} structure;
I was also able to crash by spamming F5 to continuously run a template while on the Inspector window. Not sure if this is because of a custom inspector template, but it does not happen on 16.0.4.
And as for some stuff that has existed since 16.0.4 and prior:
This template does nothing:
struct Structure {
local int32 value = 0;
} structure();
It executes sucessfully, but nothing shows up in the Variables window. There should probably be a warning or error shown in this scenario?
For some reason, the dock windows will sometimes decide to change position, and attempting to reposition them will not save and will revert to the old position upon restarting 010 Editor.
Additionally, sometimes the dock windows that have been enabled will reset. I typically only keep the Inspector, Variables and Output windows enabled, but occassionally find that they have all been enabled again when starting 010 Editor. This might be caused by a crash?